Update
Updating database... Please wait.
Tuesday 10 April 2018 at 05:10
Quoted from D-Gottlieb:I would like to quiet down the power supply fan or change the cooling solution completely. What is the best mod for this? The fan is at the top of the power supply and turns on periodically despite placing another quieter, always-on fan on top of it.
I’m in the same boat.
Source: http://pinside.com/pinball/forum/topic/stern-star-wars-clubmay-the-force-be-with-you/page/82#post-4330230
Tuesday 10 April 2018 at 05:10
Quoted from vid1900:You should offer to buy those "old pinball games" for $1000 each!
You haven’t seen them. At this point they are worth the boards and that’s it. So I’d say $1000 max. Just blows my mind that they even have them on the floor still. No way they are getting more than a handful...
Source: http://pinside.com/pinball/forum/topic/broke-mans-buying-tips/page/2#post-4330227
Tuesday 10 April 2018 at 05:08
Just checked pinrepair's guide for Bally mpu boards, and here's what it says:
Sixth Flash Completed*:
The Fakers Guide: a sixth flash means the PIA at U11 (6821) and the U12 timer (5550 chip is good. No sixth flash means either PIA U11 (6821) or its socket is bad, or the U12 (555) timer is bad. Lack...
Source: http://pinside.com/pinball/forum/topic/someone-with-working-granny-and-the-gators#post-4330226
Tuesday 10 April 2018 at 05:08
Wondering if anyone's done a rubber ring list and placement chart for Blackout. The ring kit I got from Marco has a diagram but it doesn't specify which ring goes where, and the ring list doesn't seem to match what's needed.
Source: http://pinside.com/pinball/forum/topic/blackout-club-fans-welcome/page/7#post-4330225
Tuesday 10 April 2018 at 05:07
Still some weird issue with the left shooter and left slingshot with the crane and death world...
https://m.youtube.com/watch?v=Ew2e7OxtneI
Source: http://pinside.com/pinball/forum/topic/bally-judge-dredd-going-crazy#post-4330224
Tuesday 10 April 2018 at 05:06
Have you tested the pre drive transistor that are associated to that coil?It would be located on the driver board in the backbox manual would tell you the location.It's the smaller one
Source: http://pinside.com/pinball/forum/topic/batman-forever-vuk-stuck-on#post-4330223
Tuesday 10 April 2018 at 05:06
[pinsidemarketad=62718]
Source: http://pinside.com/pinball/forum/topic/f14-plastic#post-4330222
Tuesday 10 April 2018 at 05:06
Quoted from Mistwalker:Have been enjoying this game for a little over a month now, here's my take. The game is fast, and brutal, but so much FUN! Good shots are well rewarded, sloppy shots are swiftly punished. Destroyed the Death Star once (Battle over Endor) Awesome!
Finally received all the a...
Source: http://pinside.com/pinball/forum/topic/stern-star-wars-clubmay-the-force-be-with-you/page/82#post-4330221
Tuesday 10 April 2018 at 05:06
If you put a new coil and diode in and transistor was bad, it may have blown new diode and now transistor is bad again.
LTG : )
Source: http://pinside.com/pinball/forum/topic/batman-forever-vuk-stuck-on#post-4330220