pinside

Ce site n'est pas le site officiel.
C'est un blog automatisé qui réplique les articles automatiquement

Update

Updating database... Please wait.

barakandl on "Testing/test points WMS system 6/6a boards..."

Monday 21 May 2018 at 23:08

Quoted from pb456:Ok it's such a simple question, I'm sure someone has posted it along with pictures and test points and assumed readings... But I can't find it. Does anyone know of a guide on testing readings on power, sound, solenoid, mpu boards? Thanks in advance. check the board layout drawing....

Source: http://pinside.com/pinball/forum/topic/testingtest-points-wms-system-66a-boards#post-4410433


chad on "Shaq Attaq vs Medieval Madness (original)?"

Monday 21 May 2018 at 19:13

Shaq Attack , and you could use Icy-Hot as one of many topper potentials.

Source: http://pinside.com/pinball/forum/topic/shaq-attaq-vs-medieval-madness-original/page/2#post-4409878


TractorDoc on "The now defunct"

Monday 21 May 2018 at 19:12

Quoted from chad:They will be complaining of finger issues, long term neck issues, and serious eye strain...."should have listened to our parents" "Texting Thumb" is Serious! Didn't you know? pasted_image (resized).png

Source: http://pinside.com/pinball/forum/topic/the-now-defunct#post-4409877


bigehrl on "A Strongly Worded Message For Kaneda."

Monday 21 May 2018 at 19:12

chris- i know you'll be reading this thread closely because your egotistical personality just can't resist. with that being said, i'm the person who's nose you elbowed while being tossed out of the NYC Pinball Championships by Levi, like a ragdoll, after much diplomacy on his part proved to be usele...

Source: http://pinside.com/pinball/forum/topic/a-strongly-worded-message-for-kaneda#post-4409876


timab2000 on "Evel Knievel Questions"

Monday 21 May 2018 at 19:12

Hi everyone, I recently purchased a non working Evel Knievel and had a couple of question... 1) Could not find a 1 amp slow blow fuse under playfield. Is that normal?? Could not find it on the wire diagram either. 2) And then found these 3, 455 bulbs (see pic) behind the back glass that were flas...

Source: http://pinside.com/pinball/forum/topic/evel-knievel-questions#post-4409875


PhilGreg on "Gottlieb 4 player Player Unit alignment"

Monday 21 May 2018 at 19:12

I'm trying to figure out #6 - Since the switch that goes through U to allow Ax to reset is normally closed, and U is pulling, then that switch is open thus Ax not resetting. pasted_image (resized).png Now, when I turn the machine on, U pulls from the get go, but if I look at this it would seem norma...

Source: http://pinside.com/pinball/forum/topic/gottlieb-4-player-player-unit-alignment#post-4409874


sohchx on "Stern 24 CTU owners & fan club"

Monday 21 May 2018 at 19:11

Count me in!! I had always wondered why no club thread was here. I was a huge fan of the "original" show at the time so this was a must have for me. The reboot was "meh" at best. It just wasn't the same without old Jack.

Source: http://pinside.com/pinball/forum/topic/stern-24-ctu-owners-fan-club#post-4409873


JY64 on "Will future Stern designs live up to IMDN?"

Monday 21 May 2018 at 19:11

I would say Stern should think long and hard before increasing the cost per game as people wanted hand drawn art Stern gave it to the people and they hated it think GOTG

Source: http://pinside.com/pinball/forum/topic/will-future-stern-designs-live-up-to-imdn#post-4409872


Kickout on "Cyclone Issues"

Monday 21 May 2018 at 19:11

Grumpy With J12 on the APS disconnected F4 measure good on both sides of the fuse. Plug in J12 and F4 blows. Would you recommend disconnecting the non working coils and then reconnect one at a time. Would I be able to find the bad one that way? Or could I put a jumper from each pin on J12 to it matc...

Source: http://pinside.com/pinball/forum/topic/cyclone-issues#post-4409871


uncivil_engineer on "High Speed Club ~ Dispatch, this is 504. We have a Club now, over."

Monday 21 May 2018 at 19:11

I picked up a HS this weekend that needs a little love. Does anyone have a plastic set (hopefully a new set) that they are willing to sell?

Source: http://pinside.com/pinball/forum/topic/high-speed-club-dispatch-this-is-504-we-have-a-club-now-over/page/41#post-4409870


Unknown feed type?!