Update
Updating database... Please wait.
Sunday 18 February 2018 at 14:55
Ok so changed the battery on my multi meter just to see if there was a difference and it seems the first four pins on that connector are around 25 and the last 4 are around 75.
Source: http://pinside.com/pinball/forum/topic/tftc-owners-fang-club-the-morgue-the-merrier/page/56#post-4236579
Sunday 18 February 2018 at 14:46
Hope all is well Austin. Wish you a speedy recovery with whatever it is you are dealing with.
Source: http://pinside.com/pinball/forum/topic/for-sale-world-poker-tour-20#post-4236578
Sunday 18 February 2018 at 14:45
Quoted from SealClubber:It is only the four tnt switches. I will try reinstalling the old code and see if the issue goes away and go from there.
I didnt have this problem......so far anyway
Source: http://pinside.com/pinball/forum/topic/new-acdc-code/page/5#post-4236577
Sunday 18 February 2018 at 14:42
Need pictures of wood rails inside the cabinet of FG that support Playfield.
Thanks
Source: http://pinside.com/pinball/forum/topic/flash-gordon-pictures-needed#post-4236575
Sunday 18 February 2018 at 14:42
Quoted from Nepi23:I tested and the optos at mine and saloon do not seem to be working. Solenoids fire ok in test mode.
I also noticed that the beer mug switch is not registering for some reason now.
CC swmx.jpg
Check switches #44, #47, #48 as they are in the same column.
Could be a broken wire unde...
Source: http://pinside.com/pinball/forum/topic/cc-ramp-lip-curling-solenoids-at-mine-and-saloon-not-firing#post-4236574
Sunday 18 February 2018 at 14:42
OK so now it sounds like you might have a string of switches that are not working. Enter switch edge test. Look at the diagram for the switches. (pay particular attention to the switches for the VUKs that don't work) Look to see where they are in the diagram. Is it a row or column. If you see two or...
Source: http://pinside.com/pinball/forum/topic/cc-ramp-lip-curling-solenoids-at-mine-and-saloon-not-firing#post-4236573
Sunday 18 February 2018 at 14:35
These jumper mods are pulled from the old pinball repair site that was taken down years ago, Hope they help.
WPC and WPC-S Driver Board Jumpers:
For reference, the driver board is positioned with the solder side showing, and connector J104 at the "top". All jumpers added to the solder side of the dr...
Source: http://pinside.com/pinball/forum/topic/wpc-reset-advice#post-4236571
Sunday 18 February 2018 at 14:34
IMO, it was the best overall condition of machines I have seen. Been doing this for 10+ years and I think 90% of this lineup worked and was not blown out. Obviously a few rough ones but great auction to attend to meet/greet and play some games even if you do not buy.
Source: http://pinside.com/pinball/forum/topic/tn-auction-feb-17#post-4236570